Legal Actions
I have RFI, now what– Part I, Locating it
This allows me to verify I am working with the same RFI source. I record the audio from the FT-900, and then I can play it back into Spectrum labs, and see if it matches the RFI I am hearing at home. Once I have a match, I know without a doubt I have the same source. I then look at the map, and it becomes pretty obvious where the RFI is most of the time. I next start running the frequency up as high as possible and still hear the RFI. I then grab a Google Map of a smaller area, around where the signal is strongest, and do the drive around again. I repeat this process moving ever higher in frequency. Continue reading
I have RFI, now what– Part III, Quantification
Over the past few years my RFI problem has been getting worse and worse. 40 Meters was unusable due to QRM last year, I am only now beginning to be able to use 40 meters again. Other hams in the area, (1/2 mile away), closer to the source of the RFI have lost the entire HF spectrum. See the movie above. Hit play, and all looks well until about 22:30 GMT, which is about 3:30 PM in my local time zone. As you can see, the RFI goes off scale at that time. The S Meter reading for that signal is around 10 db over S9. It is also affecting three other hams in the area. One poor fellow is so close to it that all ham bands are wiped out, 160 Meters through 10 meters are unusable during this time frame. There is another ham located about 1/4 mile from the source, he has just moved in, and was unaware why his use of 40 meters was precluded due to RFI. So there are folks who have it worse than me in this! Note this is an older recording, currently the start time for the RFI has changed to 01:36, or 7:36 PM local time. All in all there are 4 and possible 5 hams affected by what is a single source, over one or two square miles, all from a single source. We have the general area pinned down, and this summer, (2014), we are going to locate the house, and either contact the owner, or request FCC assistance. Continue reading
ARRL to FCC: “Grow Light” Ballast Causes HF Interference.
On March 14th, the ARRL published an article stating: “ARRL formally complained to the FCC, contending that a “grow light” ballast being widely marketed and sold is responsible for severe interference to the MF and HF bands”. Continue reading
